30+ Spool Thread Stand
This is our 30+ thread stand. Will hold 30 spools
of larger embroidery thread. Can be used as a thread
spool holder but best of all has our patented tensioner
disks for total control of your exterior spools
of thread. Use this model just like you would use
a wall thread rack. Except much easier to reach
your threads than if they were on the wall.
Thread Stand can hold 30 spool size up to 2"
(measurement of bottom of spool).
Our tensioner disks are the only tensioners on
the retail market that is able to control your spools
of thread within the outside of your machine. Once
your thread is connected to the tensioner disks,
you will have FULL control over your EXTERIOR thread
stitching.This technique will hold your thread slightly
as you are stitching and will give total exterior
thread control, as you will have no more broken
needles or threads and no more ruining of your precious
project. I can remember those days when I was working
on a project on my machine and all of a sudden my
exterior thread spool would fall off the machine
dowel, onto the floor, never to be found again.
Doesn't that sound just so familiar. Once you purchase
and start using our super unique thread stand you
will not be disappointed.
Special Features of our 30+ Thread Stand
- Dimensions are approx 18" x 7 1/4" Height
is 12"
- Holds 30+ spools of your favorite color thread
- The + in 30 is the BONUS - Holds 14 Bobbins
- Tensioner Disk set-up
- Makes a wonderful gift for that special crafter in your life.
- Handmade in the good OLE USA
- Made from quality Select Wood
- Has rubber feet for a NON-slip affect
- Comes 99% assembled (just place (2) screws on bottom)
- Delivered to you, natural (unfinished) so you may paint or stain to your decor
- Also another BONUS - You are able to use a spool of thread with a bottom base up to 3 1/2".
- But the 30 spool holders can only handle a 2" bottom base spool.
- Just place the larger spool under disks & start stitching
|
